Welcome to tvBETA

Hello, if you happen to be one of the founders of FTABeta, please use your old login details; if you're visiting us for the first time, please register! and contribute!

Register Now!

Prosat HD not booting after Tdragaon 2.7 upgrade

Discussion in 'Prosat V8 HD Help' started by mcostell, Jun 21, 2016.

  1. mcostell

    mcostell New Member

    Joined:
    Aug 22, 2015
    Messages:
    6
    Likes Received:
    0
    Need help

    I did the TDragon V2.7 upgrade. Display was stuck on U9 so I repowered and now display stuck on boot and wont finish booting up.

    Any suggestions?
     
    #1
  2. skyseeker

    skyseeker New Member

    Joined:
    May 27, 2011
    Messages:
    274
    Likes Received:
    0
    How to force load a file /by kash
    C/P Thanks for this procedure kash


    download the latest file

    rename it to factory_fw.udf

    Put the file on the USB drive

    USB drive will only have factory_fw.udf file

    Now unplug the unit from power

    Insert the USB drive into any USB port

    Hold the Front Power Down and keep holding it

    Plug in power to your unit

    You will see UPGRD on the front display, release the front power button

    It will take long to erase and write

    After completing it will display FINSH/done on the front display

    press the power button from the remote and it will reboot.

    do the factory reset and do your setup again.
     
    #2
  3. mcostell

    mcostell New Member

    Joined:
    Aug 22, 2015
    Messages:
    6
    Likes Received:
    0
    I did do this and it doesn't finish. I get an ER 3 in display.
    Is there anything else
     
    #3
  4. thawat

    thawat New Member

    Joined:
    Oct 3, 2010
    Messages:
    20
    Likes Received:
    0
    Is this Tdragon upgrade for Prosat V8 receiver?
    if it is any step by step to load udf file into this receiver?
    cause i try the about instruction and it don't even load.
     
    #4

Share This Page